screw feeders discharge the material into the
Weighing Hopper, which is placed on load cells.
Pre- determined quantity of material
from each Storage Hopper is fed to the Weighing
The batch controller controls
the starting and stopping of the coarse and fine
screws as per the program and quantity given in
Once the required quantity of
material is fed to the Weighing Hopper, the bottom
valve is opened to discharge the material to mixer.
The mixer can be any type like,
Ribbon Blender, Cone Screw Mixer, Agitated Vessel
etc. Once the Weighing Hopper is empty, the next
batching cycle starts. The system can be programmed
for any number of batching cycles.